Technician testing a gas furnace flame sensor with a multimeter, blue burner flames lit

Furnace repair in Louisville, KY

If the furnace will not light, lights and shuts off a minute later, or runs without warming the house, call or text us. We find the failed part, show it to you, check the venting, and write the price before the repair. Dual fuel systems included: when the heat pump hands off and the furnace does not answer, that is ours too.

  • The failed part shown to you
  • Venting and drain checked on every call
  • Dual fuel hand-off tested
  • Price written before the repair

Or call or text 502-555-0147

Tell us what the furnace is doing

We usually answer the same day, and within the hour when a house has no heat or no cooling.

No heat or no cooling and someone at home is elderly, unwell or very young? Call or text now: 502-555-0147

No heat? Check these four things first

A few minutes each. If none of them fixes it, call or text 502-555-0147. If you smell gas, leave the house and call the gas utility from outside.

  1. The thermostat.

    Set to heat, set above the room temperature, fresh batteries if it takes them.

  2. The switch and breaker.

    A light switch on or near the furnace can be turned off by accident.

  3. The filter.

    A clogged filter can overheat the furnace and shut it down.

  4. The drain.

    Water in the furnace cabinet or a full condensate pump can stop it.

Book a visit

The furnace half of dual fuel

Plenty of houses around Louisville heat with both: a heat pump for most of the winter and a gas furnace for the cold snaps. When that works, you never notice the hand-off. When it does not, the house slowly loses ground on the coldest night and nobody knows which half is at fault.

On a dual fuel call we test both: the heat pump's heating output, the thermostat's switch setting, and the furnace lighting and running on its own. A normal Louisville year has 74 nights at or below freezing (NOAA 1991 to 2020 normals), and the furnace has to be ready for the coldest of them.

Call or text 502-555-0147 when the heat stops. We usually answer the same day, and within the hour when a house has no heat and someone at home is elderly, unwell or very young. Leave the heat pump running if you have one; even on a cold day it adds heat while we sort out the furnace.

Book a visit

Technician with a flashlight at the coil cabinet on top of a gas furnace in a Kentucky basement

Common furnace repairs, and what they usually mean

RepairWhat it fixesWhat it tells us
Flame sensor cleaned or replacedLights, then shuts offThe most common winter call
Hot surface ignitor replacedNever lightsA wear part
Pressure switch or hoseInducer runs, burners do not lightOften a blocked hose or vent
Drain, trap or pump clearedShuts down, water in the cabinetHigh-efficiency furnaces make water all winter
Limit switchRuns briefly, shuts off hotOften a clogged filter or weak airflow behind it
Thermostat or dual fuel settingFurnace never takes overThe hand-off, not the furnace

What the signs usually mean

Clicks, no flame

An ignitor that has failed or a gas valve not opening.

Lights, then shuts off

A flame sensor that cannot see the flame. Cleaned or replaced in one visit.

Blows cold air

The burners are off while the blower runs, or, in dual fuel, the heat pump is running in a cold snap without its backup.

Short cycling

Overheating from a clogged filter, or a thermostat in the wrong place.

The winter a Louisville furnace is there for

  • 43.6°F

    Normal January high

    With a normal low of 27.8 (NOAA 1991 to 2020)

  • 13.2days

    With a high at or below freezing

    The days dual fuel switches to gas

  • -22°F

    Record low, January 19, 1994

    Louisville area record since 1872

While you wait for us on a cold night

Safe things to do until we get there.

Use what heats safely

Close doors to unused rooms. Use electric space heaters only on a clear floor, never a gas oven or a grill indoors.

If you have a heat pump

Leave it running. Even in a cold snap it adds heat while we sort out the furnace.

Check your CO alarm

Press the test button. If it is missing or past its date, tell us when we arrive.

Note the blinks

Most furnaces flash a status code through a small window in the door. Count the blinks; it saves time.

Furnace repair around Louisville

We drive out from Jeffersontown. Each town has its own page with the drive, the houses we see there and the office that handles the HVAC permit, because that office is not the same everywhere.

St. Matthews

About 7 miles from the office. The city wants its own Letter of Compliance before Louisville Metro issues a building permit.

Louisville

About 12 miles to the Highlands, 14 to Old Louisville. Louisville Metro Construction Review issues the HVAC permit.

Prospect

About 13.5 miles. A city in two counties, with a different HVAC permit office on each side of the line.

Mount Washington and Shepherdsville

About 12 and 21.5 miles south into Bullitt County, where permits run through the county and the city, not Louisville Metro.

Furnace repair questions we hear most

Why does my furnace light and then shut off after a few seconds?

Most often a dirty flame sensor. The furnace lights, does not detect the flame, and shuts the gas off for safety. Cleaning or replacing the sensor usually fixes it. If it keeps happening, we look at the grounding and the burners too.

My furnace has locked out. Can I reset it?

Turning the power off and on may restart it once. If it locks out again, call us; the furnace is shutting down for a reason, and repeated resets do not fix it. Note how many times the status light blinks, which helps us bring the right part.

Why does the heat pump run but the furnace never comes on in a cold snap?

In a dual fuel system the thermostat decides when to switch from the heat pump to the furnace. A wrong switch setting, a wiring fault or a furnace that will not light all look the same from the hallway: the house cannot keep up on the coldest day. We test the hand-off and the furnace together. See heat pumps.

Do you check for carbon monoxide?

Yes. On every furnace call we check the venting and test for carbon monoxide around the furnace. If you have no CO alarm near the bedrooms, we will tell you; it is the single cheapest safety step in a house with gas heat.

Is it worth repairing an older furnace?

Usually, for a sensor, ignitor or switch. If the heat exchanger is cracked or the repairs keep coming, we lay out repair and replacement side by side, including whether a heat pump with the furnace as backup makes sense.

Water around my furnace: is that a problem?

A high-efficiency furnace makes water and drains it away. A clogged drain line, trap or condensate pump will shut it down. We clear it and check that the drain is not shared with an air conditioner drain that is also clogging.

My furnace runs but some rooms stay cold. Is that a repair?

Sometimes. A weak blower, a clogged filter or a closed damper reduces airflow to the far rooms. Often it is the ducts: a disconnected run in the basement or crawlspace, or a room with no return. We measure the air at the registers and tell you which it is before we suggest anything.

Call or text 502-555-0147

Tell us what the furnace is doing

What you notice, whether there is a blinking light, and whether you also have a heat pump.

Book a furnace repair

We usually answer the same day, and within the hour when a house has no heat or no cooling.

No heat or no cooling and someone at home is elderly, unwell or very young? Call or text now: 502-555-0147

Call or text 502-555-0147